It happened that you change the stero image of your input signal ! so, naturally, part of your signal is no more the same at R and L Now you notice that if a side signal appears ! Now in Fairchild, de-link the controls switch and play with the rigth or left input channel gain knobs the way they are NOT set at the same level Now put back your pans at 0 ( middle ) : of course the is NO side-signal in the output channel Of course a side channel is empty when all your source are centered panned !īut when I pan LeftOverhead track to Left, and my RightOverhead track to Right, there is now a side-signal in the output channel If you let all your pans at 0: there is NO side-signal in the output channel
Listen only the side signal ( switch S in bx_solo ) : Now make these tests and tell me if you expirement the same as me : Put a Mid-Side Meter/ tool in your Output channelīut you can use the free plu-in bx_solo which let you switch between L, R, M, S, so you can listen a specific channel Important : my 4 tracks are all panned middle 0 ( center )Ĭreate a new buss and send all the 4 tracks to this new( drum) buss ( that I can send to you if you like to be sure we’re coming from the same point but of course you can take any takes ) Very odd.įirst, I think we have to experiment the same thingĪs we can get confused in Logic by some additionnal signal passing through the Aux), I propose to we create a new Logic project. shouldn't they allow me to control the lat/vert outputs while in lat/vert mode? In my case, if I move the "left" output control all the way down, the actual left side mutes. If I push the threshold all the way up on the Lat (mid), I should hear only the Vert (sides) components, but nope.
only Left Right when moving any controls. vary (I'm trying to get about 2db of reduction in the Lat, 0 db in the Vert) I must be doing something wrong, so here is my set-up: All I can hear is the actual left channel being compressed.
When using the 670 in Lat/Vert mode, why is that I cannot hear/listen to the compression in the Lat (mid) section while adjusting the threshold etc. I've been really loving the Fairchild Tube Limiter Collection, but have one question:
0 kommentar(er)
